Clearaudio INNOVATION + STROBOSCOPE TESTRECORD - Manual (Page 12)

Innovation /
Innovation Wood
User manual
Page 11  Clearaudio electronic GmbH 2015
12.)
The following final adjustment is very important:
Please ensure that your turntable rack is in a levelled position.
Please check with the bubble level gauge, if your Innovation turntable is in a levelled
position.
You can adjust each of the turntables`feet to get the turntable levelled.
Only if the turntable is in a levelled position you will get the best results with your
Innovation turntable.
13.)
Please connect the mains plug to your power supply.
14.)
Place one drive belt (the second is for spare) around the platter and around the motor
pulley.
By pushing the sensor-switch, marked with “33 1/3” on the motor, the turntable starts to
spin until 33 1/3 rpm is reached.
After the initial set-up we recommend to let the turntable spin for at least 15 to 30 minutes.
This ensures a smoother break in.
Pic. 11 a: Alignment of the turntable
Pic. 12: Connection power supply and motor
Pic. 11 b: Adjustment of the turntables`feets