Compass Atom 7HV Ultimate - Manual (Page 22)

Use AB Glue
A B A B
00 10 20 30 40 00 9
Canopy
Place the canopy onto the frames
and mark the right position of the
canopy insert. Mark the positions
of the holes in the anopy on the
Insert for drilling. Use a 2mm drill
and drill straight through the
insert. Use AB glue to fix the insert
and screw it from the outside into
the canopy.
3
2
5
1
4
Pos Description Qty
1 M2.5x8 Self Tapping Bolt 2
2 Canopy Insert 1
3 M3x8 Socket Head Bolt 2
4 Thumb Screw 2
5 Canopy Rubber Grommets 2
A B A B
00 10 20 30 40 00 10
Grounding
Belt-driven tailrotors can produce a high amount of electricity.
The discharge can cause a blockage of the radio signal and the
RC-Components. If you have transmission problems and/or
problems like hard tail kicks and lockouts during flight, you have
to ground the tail. We recommend to ground each helicopter for
safety reasons if you are not sure if everything works without
failures.
To ground the helicopter, use a piece of fine sandpaper to remove a little bit of
the black anodizing between the two tail boom clamps in the frame with care. Do
not modify the tailboom behind the tail boom clamps! Use a piece of silicon wire
with a diameter of at least 1mm² and skin one end. Attach the open end to the tail
boom with one or two zip ties. Lay the wire to the motor, skin the other end and
attach the wire to one motor screw by jamming the open end under the screw.
Do not use a file, rasp, knife or
coarse sandpaper to remove the
anodizing. Deep scratches will
damage the structure of the tail
boom and can cause a breakage
of the tail boom!