Ditch Witch TK Series Manual - Manual (Page 38)

TK Series Guidance System Operator’s Manual
System Operation - 37
Setup
CMW
Calibrate Tracker to Beacon
Manual Method
TX and TXH beacons have one-way communication with the tracker. To accurately scale depth, calibrate
the tracker to the beacon.
1. Activate beacon and place on ground exactly
10 ft (305 cm) from tracker, as shown.
2. Position tracker parallel to center of beacon.
3. Select Beacon>Calibrate Depth and follow
prompts.
Bluetooth Method
TXQ and TXQG beacons utilize Bluetooth radios
for two-way communication with the tracker. Once
the tracker is paired to the beacon, calibration
takes place automatically. To pair the tracker with
the beacon:
1. Activate the beacon.
2. On the tracker, go to Wireless>Bluetooth.
Select the correct TX_0000 beacon to create a connection.
3. Select Beacon>Calibrate Depth and follow prompts. This step will calibrate both UP and DOWN
modes.
IMPORTANT: If using a multi-frequency
86 Series beacon or a multi-mode TX
series beacon, calibrate each frequency
separately.
e17om051w.eps