Ditch Witch 150RT - Manual (Page 27)

Locate - 26
150R/T Operator’s Manual
Active Location
CMW
Active Location
Setup
Follow setup procedures for the type of locating you will be doing: direct connection, induction clamp, or
broadcast induction. Always check receiver battery level at startup. See “Controls” on page 13.
Direct Connection
To set up transmitter for direct connection:
1. Drive ground stake (4).
2. Plug cable into transmitter (2).
3. Hook black lead to ground stake (3).
4. Hook red lead to line (1).
5. Turn on transmitter.
6. Check battery level indicator.
Jobsite hazards could cause death or serious injury. Use
correct equipment and work methods. Use and maintain proper safety
equipment.
NOTICE: Electric shock or equipment damage can result if transmitter is connected to live cable.
Contact qualified utility personnel and follow all standards and requirements for disconnecting and
grounding lines.
NOTICE:
• Do not unplug direct connect cable
from transmitter when connected to
line. Removing cable will cause an
arc and could damage equipment
or cause injury.
• Turn off transmitter when
connecting or moving ground
stake.