Caution, Important, Operation – EarthQuake 9800B User Manual

Page 9

Advertising
background image

Check for parts online at

www.getearthquake.com or call 800-345-6007 M-F 8-5

9

Operator's Manual

Two-Man Earth Auger Powerhead 9800 Series

CAUTION

DO NOT START YOUR EARTH AUGER UNIT UNTIL YOU

HAVE READ THE ENGINE MANUAL THAT CAME WITH

YOUR ENGINE, AND THE "WARNINGS AND SAFETY

PRECAUTIONS" SECTION IN THIS MANUAL. IF YOU

HAVE READ THESE, FOLLOW THE STEPS TO START YOUR

EARTH AUGER UNIT. ALWAYS PERFORM PRE-START

CHECKLIST BEFORE STARTING THE ENGINE.
IT IS RECOMMENDED THAT THE EARTH AUGER UNIT

NOT BE TILTED AT MORE THAN A 30 DEGREE ANGLE

FROM THE UPRIGHT POSITION. FAILURE TO DO SO

CAN CAUSE FUEL AND/OR OIL LEAKAGE.

CAUTION

NEVER ADD GAS WHEN ENGINE IS RUNNING OR HOT

FROM OPERATION. NEVER FILL THE TANK INDOORS.

DO NOT SMOKE WHEN FILLING FUEL TANK.
NEVER FILL FUEL TANK COMPLETELY. FILL TANK TO 1/2"

BELOW BOTTOM OF FILLER NECK TO PROVIDE SPACE

FOR FUEL EXPANSION. WIPE ANY FUEL SPILLAGE FROM

ENGINE AND EQUIPMENT BEFORE STARTING ENGINE.
DO NOT HOLD THROTTLE LEVER WIDE OPEN WHILE

STARTING. LOSS OF CONTROL OF POWERHEAD/AUGER

COULD RESULT.
NEVER RUN ENGINE INDOORS OR IN ENCLOSED,

POORLY VENTILATED AREAS. ENGINE EXHAUST

CONTAINS CARBON MONOXIDE, AN ODORLESS AND

DEADLY GAS.
KEEP HANDS, FEET, HAIR AND LOOSE CLOTHING

AWAY FROM ANY MOVING PARTS ON ENGINE AND

EQUIPMENT.
TEMPERATURE OF MUFFLER AND NEARBY AREAS MAY

EXCEED 150° F. AVOID THESE AREAS.
BEFORE STORING UNIT, DISCONNECT SPARK PLUG

WIRE FROM SPARK PLUG AND ATTACH IT TO RETAINING

POST.
NEVER STORE ENGINE WITH FUEL IN TANK INDOORS

OR IN ENCLOSED, POORLY VENTILATED AREAS, WHERE

FUEL FUMES MAY REACH AN OPEN FLAME, SPARK OR

PILOT LIGHT.

IMPORTANT

NEVER MIX OIL WITH GASOLINE.

OPERATION

PRE-START CHECKLIST

1. Read and understand the operator's manual that came with

your unit and the engine.

2. Fill oil sump or check oil level. Check oil level often during

engine break-in.

3. Fill fuel tank. Use unleaded, regular gasoline.
4. Be sure spark plug wire is attached to spark plug.

PREPARING ENGINE FOR STARTING

TO CHECK THE OIL
1. Check the engine oil level with the engine stopped and in a

level position.

2. Remove the oil filler cap/dipstick and wipe it clean.
3. Insert the oil filler cap/dipstick into the oil filler neck, but do

not screw it in; then remove it to check the oil level.

4. If the oil level is near or below the lower limit mark on the

dipstick, fill with the recommended oil to the upper limit

mark. Do not overfill.

5. Reinstall the oil filler cap/dipstick.

FUEL RECOMMENDATIONS
Use clean, fresh, regular unleaded gasoline with a minimum of

85 octane.

• These engines are certified to operate on unleaded gasoline.

Unleaded gasoline produces fewer engine and spark plug

deposits and extends exhaust system life.

• Never use stale or contaminated gasoline or an oil/gasoline

mixture. Avoid getting dirt or water in the fuel tank.

• Occasionally, you may hear a light ‘‘spark knock’’ or ‘‘pinging’’

(metallic rapping noise) while operating under heavy loads.

This is no cause for concern.

• If spark knock or pinging occurs at a steady engine speed,

under a normal load, change gasoline brands. If spark knock

or pinging persists, see an authorized servicing dealer.

Advertising