EarthQuake E43 User Manual
Page 10
Page 10
ASSEMBLY INSTRUCTIONS ANd PARTS ExPLOSIONS
E43 Model
GetEarthquake.com
800-345-6007
STEPS FOR CLEANING BLOCk STYLE FOAM AIR FILTER
- SEE PARTS ExPLOSION ON PAGE 16.
1. Before removing the air filter cover, move the choke lever to the
choke position.
(Figure 1)
2. To remove air filter cover, squeeze the latch tabs on both sides
of the cover.
(Figure )
3. Once the latch tabs are released, remove the air filter cover by
rotating the cover away from the engine.
(Figure 3)
4. Remove the foam filter element
(Figure 4) and replace with a
new oiled filter, or clean the original foam filter with warm water
and mild soap by following the previous steps for Cleaning Air
Filter. Remember to thoroughly oil the foam filter with 30 or 40
weight motor oil and squeeze out any excess oil.
5. Reinstall the foam filter, pressing it in place to ensure that the
foam is fully seated into its sealed position.
(Figure 5)
6. Replace the air filter cover so that it fully snaps into place and
is secured by the latch tabs. Check that the cover is securely at-
tached by pulling slightly on the cover. If the cover doesn’t move
when pulled, it is secure.
Figure 1
Figure
Figure 3
Figure 4
Figure 5