Caution – EarthQuake E43 User Manual

Page 11

Advertising
background image

ASSEMBLY INSTRUCTIONS ANd PARTS ExPLOSIONS

E43 Model

Page 11

GetEarthquake.com

800-345-6007

SPARk PLUG
The recommended spark plug is a NGK BM6A which cross refer-
ences to a Champion CJ8.
1. Check spark plug at the beginning of each season.
2. Disconnect the spark plug cap, and clean any debris from

around the spark plug area.

3. Remove spark plug and replace if any of the following occur; pit-

ted electrodes, burned electrodes, cracked porcelain, or deposits
around electrodes.

4. After analysis, seat spark plug and tighten with spark plug

wrench.

• Reinstall original spark plug, tighten additional 1/2 turn.
• Installing new spark plug, adjust spark plug gap to .028” and

tighten additional 1/8 – 1/4 turn .

NOTE: Loose spark plug may overheat and damage engine.

Over tightened spark plug may damage threads in the cylinder

head.
CARBURETOR
Never tamper with factory setting of the carburetor.

TRANSPORTING YOUR EARTh AUGER

1. Never transport engine inside an enclosed space or vehicle.

Fuel or fuel vapors may ignite causing serious injury or death.

2. If fuel is present in the fuel tank, transport in an open vehicle in

an upright position.

3. If an enclosed vehicle must be used, remove gas into an ap-

proved red fuel container.

dO NOT siphon by mouth.

4. Run engine to use up the fuel in the carburetor and fuel tank.

Always run engine in a well ventilated area.

5. Wipe away any spilled fuel from engine and earth auger. Allow

to dry.

LONG TERM STORAGE

If your earth auger will not be used for more than one month, pre-
pare it for long term storage.
STEPS FOR LONG TERM STORAGE
1. Add fuel stabilizer according to manufacturer’s instructions.
2. Run engine for 10-15 minutes to ensure that the stabilizer reach-

es the carburetor.

3. Remove the remainder of the fuel from the gas tank into an ap-

proved fuel container.

4. Remove auger from powerhead and apply a thin layer of grease

to the output shaft (8913).

5. Store auger and powerhead (engine) in a vertical position.
6. Remove all debris from auger and powerhead (engine).

CAUTION

TO AVOId INJURY OR dEATh, NEVER SIPhON FUEL BY
MOUTh.
NEVER STORE EARTh AUGER WITh FUEL IN ThE GAS
TANk INSIdE AN ENCLOSEd AREA OR BUILdING.
TO PREVENT ACCIdENTAL STARTING:
ENGINE MUST BE TURNEd OFF ANd COOL, ANd
SPARk PLUG WIRE MUST BE REMOVEd FROM SPARk
PLUG BEFORE ChECkING ANd AdJUSTING ENGINE
OR EqUIPMENT.
AN AdULT MUST ALWAYS dO MAINTENANCE ANd RE-
PAIR ON ENGINE ANd AUGER.
ENGINE MUST BE ShUT-OFF, COOL, ANd SPARk PLUG
WIRE REMOVEd BEFORE ANY REPAIR OR MAINTE-
NANCE CAN BE dONE.

Advertising