EarthQuake 6065VEC - Manual (Page 14)

OPERATOR INSTRUCTIONS ANd PARTS
CRT Models 5055C & 6065VEC
Page 14
GetEarthquake.com
800-345-6007
SERvICING ThE ROTOTILLER
The following information will help you make the necessary checks
and perform the procedures required to follow the normal care
recommendations made for your rototiller unit.
If you prefer, your local authorized dealer can make these checks and
perform the required procedures for you.
To prevent accidental starting:
Engine must be turned off and cool, and spark plug
wire must be removed and secured from spark plug
before checking and adjusting engine or equipment.
MAINTENANCE
MAINTENANCE SChEdULE
Your rototiller has been designed and produced by the industry’s leading manufacturer of outdoor power equipment to provide you
with years of reliable operation.
Keeping your tiller in top running condition will prolong its life, and help you obtain optimum performance.
Please read this normal care schedule, and note the recommended care operating intervals to extend the life of your unit.
Maintenance Operation Page
Before
Each Use
50 hours or
Every Season
change forward/reverse belt 15 x
Engine maintenance 16 x x
Check or fill engine crankcase 16,EM x 2
check tiller transmission grease 16 x
check tire pressure 16 x
Lubrication 17 x
clean tine axle shaft 17 x
Lubricate wheel axle shaft 17 x
Check throttle control adjustment EM 1
EM = See engine manual
1 Adjust throttle control after first 3 hours of operation or if engine is hard to start or run-on occurs.
2 Change oil after first 5-8 hours of use, then after every 50 hours or every season. Change oil every 25
hours when operating under heavy load or in high temperatures.
WARNING !