East Coast Supercharging ECS Stage 1 2003+ Fuel System User Manual
Page 5
It is your responsibility to make sure that your connections are correct and leak free. If you are unsure
of how to properly install AN fittings be sure to look it up as this is critical to your safety and the
performance and reliability of your fuel system.)
Measure and cut 24 inches of the provided
8AN Fuel Line. Install a 8AN 120deg fitting on
both ends of the line. One end of this line will
attach to the new fuel block, and the other to
the inlet side of the Bosch 044 pump.
Take approximately 14” of the Provided 6AN
Braided Fuel Line and Install a 45deg fitting on
each end. This line will run from the outlet side
of the pump to factory fuel line. On the fuel line
side, install the provided male/male 6an union,
and the provided fuel line adapter as shown.