Echelon NodeUtil Node Utility - Manual (Page 15)

NodeUtil User’s Guide 9
example, add the –D< interface name > parameter to specify the network
interface. The text in the Target field should look similar to the following
command:
"C:\LonWorks\NodeUtil\NodeUtil.exe" -DLON2 –S
You should not need to make any other changes to the shortcut, so you
can click OK to save your changes and close the dialog.
To add the shortcut to your Windows Desktop:
1. In Windows Explorer, navigate to the folder in which you created the
shortcut to the NodeUtil Node Utility.
2. Click the shortcut and drag it to your Desktop.
To add the shortcut to your Taskbar in Windows XP:
1. In Windows Explorer, navigate to the folder in which you created the
shortcut to the NodeUtil Node Utility.
2. Click the shortcut and drag it to your Taskbar.
To add the shortcut to your Taskbar in Windows 7:
1. In Windows Explorer, navigate to the folder in which you created the
shortcut to the NodeUtil Node Utility.
2. Right-click the shortcut and select Pin to Taskbar.
The NodeUtil Main Menu
When the NodeUtil Node Utility starts, it displays introductory text followed by
the NodeUtil main menu, as shown below:
Welcome to the Echelon Node Utility application.
Activate the service pin on remote device to access it.
Enter one of the following commands by typing the indicated letter:
F1-- Show Banner.
A -- (A)dd device to list.
D -- Set the (D)omain of the network interface.
E -- (E)xit this application.
F -- (F)ind devices in the current domain.
1 -- Find devices in all (1)-byte domains.
G -- (G)o to device menu....
H -- (H)elp with commands.
L -- Display device (L)ist.
M -- Change device (M)ode or state.
P -- Send a service (P)in message.
Q -- (Q)uickly add device to list.
R -- (R)eboot 3150 device.
S -- Report device (S)tatus and statistics.
T -- (T)ransceiver parameters.
V -- Control (V)erbose modes.
W -- (W)ink a device.
Z -- Shell out to command prompt.
< -- Redirect input from a file.
> -- Redirect output to a file.
NodeUtil>