Echelon LonScanner FX Protocol Analyzer - Manual (Page 22)

16 Logging Data
Configuring the LonScanner Protocol Analyzer
You can configure the behavior of the protocol analyzer while it monitors a
channel, including:
• Setting logging preferences to control how the protocol analyzer collects
and record packets from a channel.
• Filtering packets to select which packet types are written to the log file.
• Setting the capture and monitor modes to determine whether the packets
collected from the channel are written to the log file, and whether the
protocol analyzer automatically refreshes the Packet Log display as data
is added to the log.
Setting Logging Preferences
You can use the LonScanner Preferences dialog to determine how the protocol
analyzer collects and displays data during a monitoring session. To set logging
preferences, perform the following steps:
1. Select File → Preferences to open the Preferences dialog, as shown in
Figure 8.
Figure 8. LonScanner Preferences Dialog
2. Specify your preferences. See the online help for descriptions of the fields
in this dialog.
3. Click OK to save your changes.