Echelon FT 5000 EVB - Manual (Page 23)

FT 5000 EVB Hardware Guide 15
chapter for more information about the Gizmo header). By default, this header is open as illustrated in
the following figure:
LCD, Light Sensor, LEDs, Switch, and Joystick Connections (JP31)
This set of jumpers is used to connect the LCD, Light Sensor, LEDs, and the shift register for the SW2
push button (lines 1 and 2 of three) and joystick (SW3) on the FT 5000 EVB. The 13-14 and 15-16
pins on JP31 are used with the 1-2 pins on JP32 for bitshift I/O with the SW2 push button and the
Joystick. By default, all the jumpers are connected, as illustrated in the figure below. You can use an
I/O line for other I/O functions by disconnecting the jumper that connects the I/O line to an I/O device
on the FT 5000 EVB.