Echelon LNS DDE Server - Manual (Page 126)

9. Click the OK button. The control panel enters a receive-ready state and
displays the following message while waiting for a service pin message from
another device on the network:
Now waiting for a service pin message.
10. Press the service pin on any device that can communicate with the network
interface card. The control panel sends a diagnostic message to the device
originating the service pin message using Neuron ID addressing. It will
repeat this operation, referred to as a “ping,” once a second until you click
either the OK or the Quit button (the Comm button becomes the Quit
button). The pinging behavior should look something like this (your Neuron
ID and Program ID may be different):
Received service pin, pinging node:
Neuron ID: 01 23 45 67 89 10
Program ID: A_NODE
** Ping Passed **
** Ping Passed **
** Ping Passed **
...
This series of tests confirms that the network interface card is properly
configured and can communicate with a device on the network.
11. Click OK to close the dialog, and click OK again to close the L ON W ORKS Plug
N’ Play application.
B-8 Installing the PCLTA-10/20 and PCC-10 Drivers