Electrocompaniet AW100DMB User Manual
Page 8
Technical Specifications AW100DMB :
The following technical data were measured on randomised test objects and are
typical data. All measurements are made with the following equipment:
Distortion analyser:
Tektronix AA501
Oscilloscope:
Tektronix 468
Oscillator:
Tektronix SG505
Frequency counter:
Rascal 9838
Phase meter:
Hewlett Packard 3575A
Amplifier section
Main voltage 120 V / 240 V. Clipping point of the amplifier is set to a level where total
harmonic distortion (THD) is 0.2 %.
Output Impedance (20 Hz -
20 kHz)
< 0,01 W
RCA (single) input impedance
220 kOhm
XLR (balanced) input impedance
110 kOhm
Input sensitivity for rated output
1 V
Max. peak current
> 80 A
THD (measured at 1 kHz half power, 8 Ohm)
< 0,001 %
THD (measured at 1 kHz -1 dB, 8 Ohm)
< 0,001 %
Noise (measured with both inputs shorted)
400 Hz - 30 kHz :
90 µV
10 Hz - 30 kHz :
100 µV
Rated output power
10 % change in line voltage will give app. 20 % change in output power.
8 Ohm
2 x 100 W
4 Ohm
2 x 200 W
2 Ohm
2 x 350 W
Power consumption (no load or signal)
161 W
Dimensions
Width
483 mm / 19 inches
Depth
370 mm / 14.6 inches
Height
135 mm / 5.3 inches
Weight 18Kg / 39.6 lbs.
The manufacturer reserves the right to alter these specifications without further notice.