Elenco Upgrade Kit SC300 to SC750 - Manual (Page 56)

-55-
Project #487
OBJECTIVE: To measure the voltage drop across diodes.
Set the meter (M2) to the LOW (or 10mA) setting. Turn on the slide
switch (S1) and the LED (D1) lights as the meter deflects to the middle
of the scale. The sum of the voltage drop across each components
equals the battery voltage. Bypass the LED by pressing the switch (S2).
The voltage across the 10k
Ω resistor increases, as shown by the meter
deflecting more to the right. Replace the red LED with the green LED
(D2) and then the diode (D3), to see the different voltage drops.
LED Voltage Drop
Project #488
OBJECTIVE: To make a circuit that indicates whether a door is
open or closed.
Using the photoresistor (RP) you can build a circuit that indicates if a
door is open or closed. When the door is open and light is present, the
letter “O” lights. When the door is closed and the room is dark, the letter
C lights.
The photoresistor turns the transistor (Q2) on or off, depending on the
amount of light in the room. When the transistor is on (light present),
segments B & C connect to the (–) side of the batteries and letter “O”
lights. When the room is dark, the transistor is off and the letter “C” lights.
Segments B & C are connected to the transistor.
Turn the slide switch (S1) on and the letter “O” should light. Cover the
photoresistor, simulating closing the door, and the letter “C” lights.
Open/Closed Door
Indicator