Elenco Diode/Transistor Tester Kit - Manual (Page 9)

-8-
r Remove the colored boots from the four alligator
clips (to remove the boots, clip the alligator clip
onto a pencil and slide the boot off). Slide each
boot onto the four corresponding colored wires
(black boot onto black wire, etc.).
r Solder an alligator clip to each wire as shown in
Figure N. Slide the boots back onto the clips.
r Turn the shaft of the base current control fully
counter-clockwise. Align the marker line on the
knob with “0” on the front panel, see Figure O.
Push the knob onto the shaft.
r Peel off one side of the protective backing on the
double-sided tape and attach it to the battery clip.
Now, peel off the other side and attach the clip to
the case as shown in Figure P.
r Obtain a 9 volt battery (alkaline preferred) and
press the battery snap onto the battery terminals.
r Insert the battery into the battery clip.
r Remove the backing from each rubber foot and
place them in the locations shown in Figure Q.
r Assemble the top and bottom case sections and
fasten with four 2.8 x 8mm self-tapping screws as
shown in Figure Q. Make sure the slots on the
side line up with one another.
Your transistor/diode tester is now completed and
ready for testing.
Figure N
Clip
Bend tabs
over wire
Boot
Solder
Figure O
Knob
Line on
knob
Flat head
screwdriver
blade
Pot shaft
Figure P
Figure Q
Tape
9V Battery
2.8 x 8mm Screws
2.8 x 8mm
Screws
Rubber feet
Rubber
feet
Slot
Battery
clip