Elenco Soldering Station - Manual (Page 12)

-11-
SOLDERING WIRES TO THE PC BOARD (see Figure N)
Solder the black wire from the switch to point A on the PC Board.
Solder the red wire from the AC receptacle to point B on the PC Board.
Remove the ground screw on the AC receptacle. Place the lug on the green wire from the line cord under
the screw and tighten it.
TESTING (see Figure O)
Set the power switch to the off position. Use a multimeter and measure the resistance as listed:
1. Pin 1 to pin 2 Infinite
2. Pin 1 to pin 3 Infinite
3. Pin 2 to pin 3 Infinite
Multimeter Test Lead
Figure O
1
3
2
If you do not have a multimeter continue to page 12.
Check wiring if your readings are different.
Black Wire from Switch
to point A
Red Wire from AC
Receptacle to point B
Green Wire from
Line Cord
Figure N