Elenco Soldering Station - Manual (Page 15)

Input Voltage: 120V 60Hz
WARNING
Shock Hazard
Disconnect power supply cord before
servicing unit.
Made in China
!
-14-
Attach the base to the chassis with four M15 X 4
screws and rubber feet (see Figure W).
Apply the bottom label as shown.
Apply the back label as shown in Figure X.
Assemble the iron holder as shown in Figure Y
below. Insert the iron holder into the slot on either
the right or the left side as shown in Figure Y. Set
the power switch to the OFF position.
FINAL ASSEMBLY
Warning: 300W Max.
Figure X
Knob
Bracket
Soldering iron holder
Note: Twist
clockwise
once inserted.
Note: Make sure tab
goes into key hole.
Soldering iron
holder body
Left Side Mount Right Side Mount
Iron Holder
Figure Y
Figure W M15 x 4 Screws
Rubber Feet
M15 x 4 Screws
Bottom
Label