Elenco DataCom Tester Kit - Manual (Page 27)

-26-
GENERAL MAINTENANCE
To clean, wipe the case with a damp cloth and
detergent (do not use abrasives or solvents).
When the Lo Batt. LED lights up, you need to
replace the battery. The terminator does not use
a battery.
BATTERY REPLACEMENT
The tester is powered by a single standard or
alkaline 9V battery. Use the following procedure to
replace the battery.
1. Disconnect the cables from the tester.
2. Using a phillips screwdriver, remove the battery
cover screw and open the battery cover.
3. Carefully remove the old battery and replace with
a new battery.
4. Reinsert the battery into the case, dressing the
battery leads so that they will not be pinched
between the case and the battery cover.
5. Reinstall the battery cover and screw.
MAINTENANCE
SCHEMATIC DIAGRAM