Panel assembly – Elenco Same as XP720 in Kit Form User Manual
Page 8
-7-
r Install binding posts 1-7 with the colors in order, as shown in Figure D. Insert the post into the hole and fasten
it with the nut and lockwasher. Tighten down the nut with pliers.
r Cut off the tabs on the two potentiometers and install them with the lugs up, as shown in
Figure D. Secure in place with a 5/16” lockwasher, 8mm flat washer and 7mm nut.
r Turn both potentiometer shafts all the way counter-clockwise. Line up the line on the
knobs with the first line on the voltage scale. Press knobs onto the shaft of the
potentiometers.
r Note the lug configuration on the rocker switch. Push the switch into the hole in the
chassis with lug 1 on top as shown in Figure D.
PANEL ASSEMBLY
Figure D
Lug 1
Lockwasher
Nut
Black
Red
Black
Yellow
Rocker Switch
Rear View of Rocker Switch
7mm Nuts
8mm Washers
5/16” Lockwashers
Potentiometers
* Cut off tabs
Red
Yellow
Yellow
IN
CREASE
1
2
3
4
5
6
7
1
2
3