Elenco Bigshot Camera - Manual (Page 6)

4 5
Push the axel rod from the left all
the way so that it enters the hole
in the camera body on the right.
Place the bracket on the dynamo so
that it secures the dynamo and the
two axle rods in place.
Fasten the bracket in place with two
screws, as shown above.
Build
B6. Place the dynamo into the camera
body. Make sure the dynamo gear
meshes correctly with gear B. Don't try
to rotate any of the gears as it may
cause the axle rods to pop out of their
positions.
B7.
B8. B9.
Take the hand crank and push-fit its
triangular notch onto the triangular
head of gear A of the gearbox.
B10. Fasten the hand crank onto gear A
using three screws, as shown.
B11.
B Power Generator
Learn about dynamo
http://www.bigshotcamera.com/learn/power/dynamo Learn about power generator
http://www.bigshotcamera.com/learn/power/index