EMM Labs XDS1 - Manual (Page 21)

021 Appendix A - Serial Remote Control (RS232) XDS1 V2 CD/SACD PLAYER OWNER’S MANUAL
Status bytes sent from XDS1 V2 (cont`d)
Byte 5 Track number ones in ASCII
Byte 6 Track number tens in ASCII
Bytes 7 through 9 are status bytes where each bit represents a machine status flag. 0 indicates
that the particular bit is set.
Byte 7
bit 0 - 1 when "Reading" indicator is on (front panel)
bit 1 - 1 when "Repeat Track" indicator is on( front panel)
bit 2 - 1 when "Repeat All" indicator is on (front panel)
bit 3 - 1 when "CD" indicator is on (front panel)
bit 4 - 1 when "SACD 2CH" indicator is on (front panel)
bit 5 - 1 when "SACD MCH" indicator is on (front panel)
bit 6 - Not used
bit 7 - Not used
Byte 8
bit 0 - Reserved
bit 1 - Not used
bit 2 - Not used
bit 3 - 1 when "No Disc" indicator is on (front panel)
bit 4 - 1 when internal clock selected
bit 5 - Not used
bit 6 - 1 when in pause
bit 7 - 1 when clock is locked
Byte 9 <CR> (x0D)
© 2013 EMM Labs Inc., All Rights Reserved. EMM Labs reserves the right to amend specifications & design without notice.