EMM Labs DAC2 AUDIO CONVERTER - Manual (Page 13)

013 Operation
© 2010 EMM Labs Inc., All Rights Reserved. EMM Labs reserves the right to amend specifications & design without notice.
DAC2 AUDIO CONVERTER OWNER’S MANUAL
Basic Operations and Input Connections
2. DAC2 Input Connections (cont’d):
EMM Optilink is selected as the digital source (connected to an EMM Labs
transport).
Above is another example. Here the DAC2 is connected to an AES digital source with
a base frequency of 48kHz (PCM 48kHz or 96kHz audio). For AES connections the
DAC2 uses a single AES input to carry 2 channels of PCM audio up to 96kHz.
NOTE: If the LOCK light is not ON then the DAC2 is not receiving appropriate
digital audio from the digital source. The DAC2 will automatically mute all the
outputs if it does not receive a proper digital audio signal from the selected source.
Check the source setup and cable connections for problems.
3. Using the remote and pressing the “Display DAC” button turns off all the DAC2 LEDs
except the LOCK light.