EMM Labs TSD1 CD/SACD TRANSPORT User Manual
Page 16
016
Appendix A - Serial Remote Control (RS232)
© 2010 EMM Labs Inc., All Rights Reserved. EMM Labs reserves the right to amend specifications & design without notice.
TSD1 CD/SACD TRANSPORT OWNER’S MANUAL
Commands to the TSD1 (cont`d)
Status bytes sent from TSD1
The TSD1 sends back 9 Bytes terminated with a <CR> whenever any status changes.
<Byte 0><Byte 1><Byte 2><Byte 3><Byte 4><Byte 5><Byte 6><Byte 7><Byte 8><CR>
Byte 0 Seconds ones in ASCII
Byte 1 Seconds tens in ASCII
Byte 2 Minutes ones in ASCII
Byte 3 Minutes tens in ASCII
Byte 4 Hours ones in ASCII
Byte 5 Track number ones in ASCII
Byte 6 Track number tens in ASCII
Byte 7
bit 0 - 1 when "Reading" indicator is on (front panel)
Command
Function
dim
Toggles through display brightness settings
try
Tray open and close
tr(x)
tr followed by a single digit (x) to jump to a particular track. See example.
tr(x) example:
a) Jump to track 5
:
tr0<CR>, tr5<CR>
b) Jump to track 12 :
tr1<CR>, tr2<CR>
c) For SACDs, function would be quicker if implemented this way:
i. Jump to track 5 :
tr0<CR>, tr0<CR>, tr5<CR>
ii.Jump to track 12 :
tr0<CR>, tr1<CR>, tr2<CR>