EMM Labs DCC2 DIGITAL CONTROL CENTER - Manual (Page 2)

DCC2 User Manual
DCC2 Digital Control Center
The DCC2 is a stereo D/A converter with built-in pre-amplifier that evolved from EMM
Labs’s acclaimed converter and pre-amplifier systems that have been used worldwide in
professional recording studios to master some of the finest recordings in both CD and
SACD releases.
The D/A section provides conversion from a wide variety of digital input formats to analog
audio, and the pre-amp section provides 2 analog inputs and 1 analog output. There is an
additional analog output that bypasses the pre-amp section.
Features
• 2-channel conversions:
• from PCM (44.1kHz, 48kHz, 88.2kHz, 96kHz) to analog
• from DSD to analog
• Supported digital input formats:
• AES/EBU (2 connectors and 1 connector)
• SPDIF (Coax)
• Optical TOSLink
• PCM over optical ST glass (AES formatted)
• RAW DSD
• SDIF-3 (DSD)
• EMM OptiLink
• Analog Inputs
• Balanced on XLR (switchable to be unbalanced)
• Unbalanced on RCA
• Analog outputs
• Balanced on XLR for signals after pre-amp
• Unbalanced on RCA for signals after pre-amp
• Balanced on XLR for signals bypassing pre-amp
• Unbalanced on RCA for signals bypassing pre-amp
• Analog output impedances
• 100Ω balanced, 50Ω unbalanced
Note: XLR analog inputs and outputs are balanced with pin 2 hot, pin 3 cold and pin 1
ground.
• Power supply
• Power factor corrected
• Factory set to 100V or 115V or 230V, 50/60Hz
• Power consumption: 60W
• Remote control: Infrared
• Dimensions W x D x H: 435 x 400 x 92mm
• Weight:
11kg
2