EMM Labs CDSD DISC TRANSPORT - Manual (Page 13)

CDSD User Manual
B: Upgrading the Software of your CDSD
Your CDSD is controlled by an internal processor that can be programmed with software
to enhance or add new features. EMM Labs is constantly working to refine this software
so your CDSD always offers the state-of-the-art sonic performance.
If a new update becomes available EMM Labs will distribute it along with a software
application that will connect your CDSD via its USB connector to a PC.
First Time Installation and Upgrade Procedure:
1. Do not connect the CDSD yet to the PC
2. Launch the supplied application “emmsetup.exe” on your PC and closely follow
instructions on the screen. Connect your CDSD to the PC only when told so.
3. When you reach the following screen, make sure to point the field “File to
Transfer” to the file supplied by EMM Labs.
4. When completed, turn off power to the CDSD (switch on back panel), wait 15
seconds and power it back on again. DO NOT POWER OFF BEFORE
PROGRAMMING IS COMPLETE (which can take up to 1 minute).
13