ENMET GSM-60 - Manual (Page 26)

GSM-60 ENMET Corporation
23
5.3.8 Set New Password
To change the password, you must enter the maintenance menu. Press the OPTION switch until “Enter Maint Menu” is displayed
then press SELECT switch for the Enter Password menu. Enter the valid password as described in Section 5.2.1.
To set a new password, after inserting a valid password,
Press the OPTION switch until; " Set New Password” is displayed.
Press the SELECT switch; " Password
❚
1270 " is displayed, with the underscore cursor under the left digit.
Use the OPTION switch to change the left digit, when the desired digit is displayed.
Press the SELECT switch to lock the digit in place and move the cursor one digit to the right.
When all four digits of the new password have been selected, " Set New Password " is displayed.
Record the new password; without it, the maintenance menu cannot be reentered once you exit the Maintenance Menu. If the
password is lost, call
ENMET customer service personnel.
From the " Password XXXX " position,
Press the SELECT switch to return to Set New Password section.
Press the OPTION switch; to continue to " exit MAINTENANCE Menu "
Example: Set Password Flow Chart
5.3.9 Exit Maintenance Menu
From the " exit MAINTENANCE Menu " position
Press the SELECT switch to resume the operational display.
Press the OPTION switch to reenter the maintenance menu at the " Calibration " position.
Example: Exit Maintenance Menu Flow Chart
O
S MAINTENANCE MENU
Set New Password
Password
❚0000
O
S
Changes digit indicated by underscore cursor
Locks underscored digit and moves cursor to next digit
MAINTENANCE MENU
Calibration
MAINTENANCE MENU
Exit maint menu
CH-1 CH-3
CH-2 CH-4
S O
O = Press Option
S = Press Select