Eurocom P370EM Scorpius - Manual (Page 112)

BIOS Utilities
5 - 10 Advanced Menu
5
SATA Mode (Advanced Menu)
You can configure SATA (Serial ATA) control to operate in either AHCI (Ad-
vanced Host Controller Interface) or RAID (Redundant Array of Independent
Disks) modes from this menu. The SATA mode should be set BEFORE installing
an operating system, and after you have backed up all necessary files and data (see
sidebar). See
“Setting Up SATA RAID Mode” on page 7 - 2 for details if you are
configuring you hard disks in a RAID.
Legacy USB Support (Advanced Menu)
Choose “Enabled” if you intend to use USB devices in systems which do not nor-
mally support USB functionality (e.g. DOS). The default setting is “Enabled” and
does not need to be changed if you intend to use your USB devices in Windows.
Boot Logo (Advanced Menu)
Use this menu item to enable/disable the Boot Logo screen at system startup.
Power On Boot Beep (Advanced Menu)
Use this menu item to enable/disable the beep as the computer starts up.
Battery Low Alarm Beep (Advanced Menu)
Use this menu item to enable/disable the battery low alarm beep.

SATA Mode
Selection
Set the SATA mode BE-
FORE installing your
Windows 7 operating
system. Do not change
the mode unless you in-
tend to reinstall your op-
erating system, and
make sure you back up
all necessary files and
data before doing so.