Eurocom D90xC PHANTOM-X - Manual (Page 110)

Modules
7 - 4 Setting Up SATA RAID or AHCI Modes
7
SATA RAID or AHCI Setup Procedure (BIOS)
1. Start-up your notebook computer and press <F2> to enter the BIOS.
2. Go to the Advanced menu, select "SATA Mode" and press Enter.
• For RAID Mode: - Set "SATA Mode" ( “SATA Mode: (Advanced Menu)” on
page 5 - 8 ) to "RAID".
OR
• For AHCI Mode: - Set "SATA AHCI Enable" (
“SATA Mode: (Advanced
Menu)” on page 5 - 8 ) to "AHCI".
3. Press Esc and go to the Boot menu.
4. Set the CD/DVD-ROM Drive (make sure the Microsoft Windows OS CD is
inserted) as the first device in the boot order from the Boot menu.
5. Select Exit Saving Changes from the Exit menu (or press F10 and Enter) and
press Enter to exit the BIOS and reboot the computer.
6. For RAID mode see the instructions in “RAID Setup (Intel Matrix)” on page 7 - 5 .
7. For AHCI mode simply install the Intel Matrix driver (see “Intel Matrix Driver
Installation” on page 7 - 7 ).