Eurocom D90xC PHANTOM-X - Manual (Page 143)

Troubleshooting
Problems & Possible Solutions 8 - 7
8
Problems & Possible Solutions
Problem Possible Cause - Solution
You turned the power on
but it doesn’t work. Battery missing / incorrectly installed. Check the battery bay, make sure the battery is present and
seated properly (the design of the battery only allows it to go in one way). Make sure there’s
nothing interfering with the battery contacts.
The Battery LED power
indicator ,
is blinking
orange.
Low Battery. Plug in the AC power source. If the computer doesn’t start up immediately, turn it off
then on again.
You are losing battery
power too quickly. The system is using too much power. If your OS has a Power Options scheme (see “Power
Plans” on page 3 - 4 / “Power Schemes” on page D - 17 ) check its settings. You may also be
using an ExpressCard/USB device/external device that is drawing a lot of power.
Actual battery operating
time is shorter than
expected. The battery has not been fully discharged before being recharged. Make sure the battery is fully
discharged and recharge it completely before reusing (see
“Battery Information” on page 3 -
10 / “Battery Information” on page D - 21 ).
Check the settings of any active power plan (see “Power Plans” on page 3 - 4 / “Power
Schemes” on page D - 17 ).
A peripheral device/USB device/ExpressCard is consuming a lot of power. Turn off/remove the
unused device to save power.