EXFO FTB-610 Wideband Copper Test Module - Manual (Page 198)

TDR Test
190 FTB-610
Auto TDR
Select Cable
The Cable Selection page allows you to set cable parameters for the Auto
TDR test.
To select cable values:
1. From the Auto TDR page, click the Select Cable button to open the
page.
2. In the Cable Selection page, edit the cable parameters as required.
3. Tap Close to confirm and close the page.
The page allows you to set or view the following parameters:

Cable Type allows you to select a cable entry (with its associated
parameters) from the current Cable Book, to use for testing. The
selection is not saved when leaving the test. The current Cable Book
entry is shown by default.

Cable Fill read-only entry displays the type of material the cable is
filled with: Aircore, Jelly, Pulp, 5 PR, or 2 PR. Setup in the Cable Book.

Velocity of Propagation read-only entry is the velocity of propagation
for the cable as a ratio of the speed of light. Setup in the Cable Book.

Cable Temperature allows you to change the temperature of the cable
under test in either degree C or F.