EXFO FTB-800 Series for FTB-1 - Manual (Page 359)

Test Results
NetBlazer 349
Summary (EtherSAM)
Service Configuration/Performance Test Buttons
Tap Service Configuration Test or Service Performance Test button to
view the result summary of the corresponding test.

Service indicates the service’s number and name.

Direction, available with Dual Test Set, indicates results from local to
remote (L -> R) and remote to local (R -> L).

Service Performance Test column displays the pass/fail verdict icon
indicating if the service complies to the configured SLA parameters.

Service Configuration Test column displays the pass/fail verdict icon
indicating if the service complies or not to the configured SLA
parameters.
Committed

Frame Loss indicates the percentage of frames that are lost. The
reported value is the maximum percentage of Frame Loss from all
burst sequences and ramp steps excluding the CIR+EIR, EBS, and
Traffic Policing steps.

Max. Jitter (ms) indicates the maximum measured delay variation.

Max Latency (ms) indicates the maximum measured round-trip
latency (delay). For Dual Test Set the local to remote and remote to
local values are reported for One-Way Latency Measurement Mode
while a single round-trip value is reported for Round-Trip Latency
Measurement Mode (see Global Options on page 123).

Avg RX Rate, for Service Performance Test, indicates the measured
average utilization throughput.
Excess
Max RX Rate, for Service Configuration Test, indicates the measured
maximum utilization throughput.