EXFO FLS-2200 Broadband Source - Manual (Page 28)

Setting Up Your Broadband Source
20 FLS-2200
Setting the Drive Current
Setting the Drive Current
You can adjust the source’s drive current to better suit your needs. The
drive current can be increased or decreased by steps of 1 mA or 10 mA.
On a dual-source, each one has its own set of control buttons and has an
independent drive current value.
Note: You can set the drive current even while the source is not emitting.
To set the drive current:
1. Press the
button to increase the value by steps of 1 mA.
OR
Press the button to decrease the value by steps of 1 mA.
2. To increase or decrease the value by steps of 10 mA, hold the
corresponding button down.
The displayed current value on the screen changes accordingly.
3. If you have a dual-source, you can repeat the above steps to set the
drive current for the second source.
BROADBAND SOURCE FLS-2200
ENTER
Setup
Active
Out
On/Off Power
Power
Source 2
Increasing and decreasing buttons
On/Off Power
Power
Source 1
Power
Power