EZ-ACCESS FORTRES OSHA STAIR SYSTEM - Manual (Page 6)

Page 6 of 6
5. OVERSIZED FEET INSTALLATION (OPTIONAL EQUIPMENT):
5.1. Loosen the leg adjustment bolts in each platform and riser corner pocket, but do not remove; then
remove the existing legs (FIG. 3).
5.2. Insert the legs included with the oversized feet into the corner pockets with the open side of the channel
oriented toward the leg adjustment bolt & washer and the square nut inside the leg (FIG. 5).
The two short legs install in the bottom of the riser and the four long legs in the platform.
5.3. Install an oversized foot onto each leg with the foot oriented under the platform or riser as shown in FIG.
5, adjust to the desired height and tighten both the thumb screws in the feet and the leg adjustment bolts
in the corner pockets securely.
5.4. Proceed with the remaining installation steps described above.
FIG. 5