Gryphon Antileon Signature Mono - Manual (Page 19)

TROUBLE-
SHOOTING
No Light in Gryphon Logo
*Check both AC cords
*Check both on/off switches on
rear panel
*Check your domestic AC supply
*Check AC fuses on rear panel
*Check fuse no.4 under top plate
(200 mA )
Logo Light is on but amplifi-
er will not start up.
*Check error indicators on dis-
play
Error and Fuse indicator is
flashing.
*Check Fuse no. 3 under top
plate. ( Remove AC cords first )
Error and Low Powe r indi-
cators are flashing.
*Available AC power is too low.
Minimum requirement is:
100 - 120v. countries : 95 v.
200 - 240v. countries : 190 v.
Error and Temp. L indica-
tors are flashing:
Left channel is overheating. Turn
off amplifier and secure air circu-
lation around the unit. Start
amplifier again after 5 min.
Error and Temp R . indica-
tors are flashing:
Right channel is overheating.
See above.
Tweak Alert
In the best Gryphon tradition we
have spent a huge amount of
time with our prototypes before
we release a new product. We
are obsessed with what we do
and consider ourselves to be
open-minded and are fascinated
by the "Grey area" between logi-
cal, technical facts and things we
just hear that make no obvious
technical sense.We will imple-
ment them as long as it does not
sacrifice safety or reliability. In
the Antileon design a number of
tweaks can be found and the
result is a fine balance that can
easily be disturbed.
We strongly advise against any
alteration of the original design,
it will void the warranty and most
certainly only provide a diffence,
not a real improvement of musi-
cal realism.
We are fully aware of the fun of
playing with AC conditioners,
bricks, platforms, cables and so
on. We appreciate much of it,
but please listen to our intentions
before you go ahead and if you
do, do yourself (and us) the favor
of now and then going back and
listening to the "naked" design
as it was intended.
19