Hanna Instruments HI 8751 - Manual (Page 5)

9 8
TEMPERATURE PROBES & ACCESSORIES
HANNA instruments ® offers a wide range of temperature probes for measure-
ments in air, surface, liquid and for penetration applications.
These probes use highly sensitive thermistor sensors to provide greater accuracy,
faster response and a temperature range that is superior to conventional
thermistor probes.
HI 765 series of temperature probes are supplied pre-calibrated at the factory
and ready to use, making it possible to switch from one to another without
needing time-consuming and tedious calibration procedures.
Different handle colors are available to avoid cross contamination during testing.
HI 765A
Air/gas probe with 1 m (3.3') cable and white handle
HI 765A/10 Air/gas probe with 10 m (33') cable and white handle
HI 765BL
General purpose/liquid probe, 1 m (3.3') cable & black handle
HI 765BL/10 General purpose/liquid probe, 10 m (33') cable & black handle
HI 765L
General purpose/liquid probe, 1 m (3.3') cable & white handle
HI 765L/10 General purpose/liquid probe, 10 m (33') cable & white handle
HI 765PBL Penetration probe with 1 m (3.3') cable and blue handle
HI 765PBL/10 Penetration probe with 10 m (33') cable and blue handle
HI 765PG
Penetration probe with 1 m (3.3') cable and green handle
HI 765PG/10 Penetration probe with 10 m (33') cable and green handle
HI 765PR
Penetration probe with 1 m (3.3') cable and red handle
HI 765PR/10 Penetration probe with 10 m (33') cable and red handle
HI 765PW
Penetration probe with 1 m (3.3') cable and white handle
HI 765PW/10 Penetration probe with 10 m (33') cable and white handle
HI 765W
Wire probe without handle for hard-to-reach places, 1 m (3.3')
cable
HI 765W/10 Wire probe without handle for hard-to-reach places, 10 m (33')
cable
BATTERY REPLACEMENT
These instruments are powered by a 9V battery.
When the battery level is too low to ensure reliable readings, the Battery Error
Prevention System (BEPS) automatically shuts down the LCD.
For a correct functioning of the instrument, replace the battery.
To access the battery, remove the battery cover
on the rear of the meter by applying pressure
in the indicated direction.
Replace the battery with a new one and
reattach the cover.
Battery replacement must only take place in a
safe area and using a 9V alkaline battery.
BATTERY
OTHER ACCESSORIES
HI 710002 Soft carrying case
HI 710009 Shockproof rubber boot, blue
HI 710010 Shockproof rubber boot, orange
HI 721316 Rugged carrying case