Hase Lima - Manual (Page 35)

35
this process unless absolutely necessary.
Make sure the room is well-ventilated and
open the windows and outside doors. If
needed, use a fan for faster air circulation.
If the maximum temperature is not reached during
the first heating operation, you may notice an odour
for a short period of time the next time the stove is
used as well.
7. Lighting the Fire
The firing up phase should be as short as possible,
since higher emissions can occur during this phase.
The slider settings described in Table 1 (see figure
on the right) are recommendations that were de-
termined under conformance testing conditions, in
compliance with the relevant standard. Depending
on the weather conditions and the draught capability
of your chimney, accordingly adjust the slider posi-
tions for your Lima to the local conditions.
NOTE!
The Lima may only be operated when the
fire box door is closed; the fire box door
may only be opened to add fuel.
WARNING!
Never use spirits, petrol, or other flamma-
ble fluids to light the stove.
Lighting the Fire
Procedure Position of Control
Elements
Completely open primary
and secondary air. Pull primary and second-
ary air slider all the way
out.
Open fire grate. Pull out fire grate slider.
Pile up any remaining ash
and unburned Charcoal
into the centre of the
combustion chamber.
Place 2-3 small logs into
the middle of the fire box;
stack approx. 0.5 kg of
dry wood chips on top.
Light the ignition material
at several places.
Tab. 1
8. Adding Fuel / Heating at
Nominal Thermal Output
More fuel should be added to the fire when the
flames from the previous burning off phase have
just gone out.
Adding Fuel / Heating at Nominal Output
Procedure Position of
Control Elements
Adjust primary and
secondary air.
Close primary air slider,
set secondary air slider to
position 2,5 - 3.
Close fire grate. Push in fire grate slider.
Add two logs weighing
approx. 1.5 kg in total.
Place logs with one end to
the front of fire box. Only
add a single layer of fuel.
Open fire box door.
Tab. 2