Hatteland Display 15 inch - JH 15T17 MMC-S (Slim Model) - Manual (Page 19)

19
IND100133-44
Connection area of unit (illustration)
Physical Connections - MMC / xxC based units
PS/2 Mouse and PS/2 Keyboard INPUTS:
Connect the PS/2 mouse cable to the PS/2 5P Connector (female) marked with an Icon.
Connect the PS/2 keyboard cable to the PS/2 5P Connector (female) marked with Icon.
Network INPUT/OUTPUT:
Supports 10/100/1000Mbps Ethernet (LAN). Suitable for twisted pair cables CAT.5E. Make sure the network cable
connector ”clicks” into the RJ-45 connector.
USB 2,3,4,5 INPUT/OUTPUT:
Supports any USB1.1 (12Mbps) and USB2.0 (480Mbps) compliant peripherals. Drivers for most USB devices are
usually included in operating system or on separate installation DVD’s delivered with Third Party products. USB 1.1
devices will operate in USB 1.1 mode (12 Mbps).
Note: The unit may also be factory configured with front USB connector.
DVI-I OUT:
DVI/RGB OUT enables a direct clone signal output from the computer. You may choose to use a DVI-I 29P cable
directly or use a DVI-I -> RGB adapter to use a RGB/VGA HD D-SUB 15P instead for this purpose. Connect the cable
to the Connector (female) and secure it to the hex spacers provided on the unit. Connect the other end to your
equipment and secure it.
LPT1 Parallel Port INPUT/OUTPUT:
Standard LPT1 Printer/Parallel (Bi-Directional/EPP/ECP) port using a D-SUB 25P Female connector. Fasten the cable
to the connector using the provided screws on the cable housing itself.
DVI-I/RGB OUT 2 x GigaBit LAN
PS/2 Keyboard Parallel (LPT) COM1, COM2 PS/2 Mouse USB 2,3,4,5
Compact Flash Reader Power Input AC Power Input DC
Grounding Screw