Physical connections - mmc / xxc based units 20 – Hatteland Display 15 inch - JH 15T17 MMC-S (Slim Model) User Manual

Page 20

Advertising
background image

Physical Connections - MMC / xxC based units

20

IND100133-44

CompactFlash Reader:

CompactFlash Reader supports Type I & II cards. Insert the card gently into the slot with the logo facing towards the

TFT display (only when the unit is off). The card is removed by pressing the EJECT button next to the card slot. A wide

range of card sizes are supported.

NOTE: DO NOT ATTEMPT TO REMOVE THE FLASH CARD WHILE THE UNIT IS OPERATING!

This is based on that the CF Slot has been configured to operate as a IDE device. If the Flash Card is removed from the slot while the unit

is on, data may be lost or partly corrupted.

COM1,2 Serial Port INPUT/OUTPUT:

Supports RS-232/422/485 opto-isolated using D-SUB 9P Male connectors. Fasten the cable to the connector using

the provided screws on the cable housing itself.

POWER INPUT:

The internal AC power module supports both 115VAC/60Hz and 230VAC/50Hz power input. Please check

specifications for your unit.

+ -

POWER INPUT: (For units supporting DC input)

Connect your DC power cable to the 2P Amphenol FCC17 D-SUB Connector (male). Secure the cable to the hex

spacers provided on the unit, and secure the other end to your power supply. The internal DC power module supports

24VDC. Please check specifications for your unit.

MULTI-POWER NOTE:

Note: You may connect either AC power or DC power or both. In case both sources are connected, power will be

sourced from the AC input. If AC input is lost, there will be a uninterrupted switch-over to DC input.

GROUNDING SCREW:

Please review “General Installation Chapter”, pt. 9 for more information.

Advertising