Heath Consultants Sure-Lock Distance Pro - Manual (Page 32)

29
above indicators) and the receiver is positioned directly above the conductor, the
display.
Each of these indications gives the operator valuable information about the
conductor being traced. It is an indication that the conductor has NOT been
pinpointed if aLL the above do not occur.
Conductor Depth Procedure
Once the conductor has been pinpointed using the audio and visual indicators as
previously described, the operator may then perform a calculated depth indica-
tion reading.
-
1. While maintaining a vertical position, rest the tip of the probe on the
-
lar to the conductor.
2.
right of the operator.
3. -
onds to obtain an automatic calculated depth calculation.
4.
CeNTeR of the conductor. The receiver features automatic return to
search mode and estimated depth.
5. It is good practice to take at least 2-3 depth readings as a cross check.
To repeat a depth reading, maintain a vertical position.
If a depth indication does not appear on the display or there is not logical se-
b. Air-coupling to the transmitter.
c. Interference from other conductors.