Imaxrc B610-PRO - Manual (Page 6)

Lithium battery(Lilo/LiPo/LiFe)program Lithium battery(Lilo/LiPo/LiFe)program
09 10
Lithium battery(Lilo/LiPo/LiFe)program
These programs are only suitable for charging and discharging Lithium batteries with a
nominal voltage of 3.3v,3.6v and3.7v per cell.These batteries need to adopt different
charge technique is termed constant voltage(CV) and constant current(CC)
method.The charge current varies according to the battery capacity and
performance.The final voltage of charge process is also very important;it should be
precisely matched with the charged voltage of the battery.They are 4.2V for Lipo,4.1v
for Lilo,and 3.6V for LiFe.The charge current and nominal voltage as for cell count set
on the charge program must always be correct for battery to be charged.
When you are willing to alter the parameter value in the program,press Start key to
make it blink then change the value with INC or DEC key.The value will be stored by
pressing Start key once.
Charging Lithium battery
The left side of the first line shows the type of
battery you select at the users setting.The value
on the left side of second line sets a charge
current and the value on the right side of second
line sets the voltage of the battery pack.
After setting the current and voltage press Start
key for more than 3 seconds to start the
process.(Charge
current:0.1~10.0A,Voltage:1~6series)
This shows the number of cells you set up and the
processor detects.'S:'is the number of cells
selected by you at the previous screen.If both
numbers are identical you can start charging
press Start button.If not,press Batt type button to
go back to previous screen.Then carefully check
the number of cells of the battery pack to charge
again.
The screen shows the present situation during
charge process.To stop charging press Batt type
key once.
Li3S 2.0A 12.59V
CHG 022:43 00682
LiPo CHARGE
2.0A 11.1V(3S)
Charging Lithium battery at balance mode
This is for balancing the voltages of Lithium batteries of the battery pack to be
charged.To do this,the battery pack being charged should have the individual cell
connector.And connect it to the individual port at the right side of charger with a
suitable connection cable that fits with your battery pack.And also,you should to
connect the battery output plug to the output of charger.
In this mode,the charging process will be different from ordinary charging mode.The
internal processor of the charger will monitor the voltages of each cell of the battery
pack and controls the charging current that is feeding to each cell to normalize the
voltage.
The value on the left side of second line sets a
charge current and the value on the right side of
second line sets the voltage of the battery pack.
After setting the current and voltage press Stsrt
key for more than 3 second to start the
process.(Charge current:0.1~10.0A,Voltage:1~6
series)
This shows the number of cells you set up and the
processor detects,'R:'shows the number of cells
found by you at the previous screen.If both
number are identical you can start charging by
press Start button.If not,press Batt type button to
go back to previous screen.Then carefully check
the number of cells of the battery pack to charge
again.
The screen shows the present situation during
charge process.To stop charging press Batt type
key once.
Individual cell connection diagram(pin-assignment of 8-pin)