Imaxrc B610-PRO - Manual (Page 8)

NiMH/NiCd battery(Lilo/LiPo/LiFe)program
13 14
These programs are for charging or discharging NiMH (Nickel-Metal-Hydride) or NiCd
(Nickel-Cadmium) battery commonly used for R/C model applications.To alter the value
at the display,press Start/Enter key to make it blink then change the value using INC>
or <DEC key. The value will be stored by pressing Start/Enter key once.
To start the process,press Start/Enter button for more than 3 seconds.
This program simply charges the battery using the
current you set.In 'Aut' mode,you need to set the
upper limit of charge current to avoid from higher
feeding current that may damage the battery.
Because some batteries of low impedance and
small capacity can lead to the higher charge
current by the processor at automatic charge
mode.But in 'Man' mode,it will charge the battery
with the charge current you set at the display.
Each mode can be switched by pressing INC>
and <DEC button simultaneously when the current
field is blinking.
The screen displays the current state of charging.
To stop the process press Batt.Type/Stop key
once. The audible should indicates you the end of
process.
Charging NiCd/NiMH battery
NiMH/NiCd battery(Lilo/LiPo/LiFe)program
Discharging NiCd/NiMH battery
Set discharge current on the left and final voltage
on the right.The discharge current ranges from
0.1 to 5.0A and the final voltage ranges from 0.1
to 25.0V.To start the process,press Start/Enter
key for more than 3 seconds.
The screen displays the current state of
discharge. You can alter the discharge current by
pressing Start/Enter key during the process.Once
you change the current value,store it by pressing
Start/Enter button again. To stop discharging
press Batt.Type/Stop key once.The audible
sound indicates you at the end of process.
Charge-to-discharge & discharge-to-charge cycle NiMH/HiCd battery
Set the sequence on the left and the number of
cycle on the right.You can use this function for
balancing,refreshing and breake-in the
battery,there will a brief cool-off period that
already fixed at 'User setting' after each charge
and discharge process.The cycling number
ranges from 1 to 5.
To stop the process,press Batt.Type/Stop key
once. You can change the discharge or charge
current by pressing Start/Enter key once during
the process.The audible sound indicates you the
end of process.
At the end of the process,you can see charged or
discharged electric capacities of the battery of the
battery at each cyclic process.
By pressing INC> or <DEC button,the screen
shows the result of each cycle in order.
NiMH CHARGE AUTO
CUR LIMIT 5.0A
NiMH 2.0A 7.42V
CHG 022:45 00890
NiMH DISCHARGE
3.0A 11.5v
NiMH 2.0A 7.42V
DSC 022:45 00890
battery
type elaopsed
time
charge
current
battery
capacity
charged
capacity
battery
type elaopsed
time
charge
current
battery
capacity
charged
capacity
DCHG 1 1314mAh
CHG 1 1430mAh
NiMH 2.0A 7.42V
D>C 022:45 00890
NiMH CYCLE
DCHG>CHG 3