Konig Electronic WLAN router 300 Mbps - Manual (Page 40)

Connection control Check "Connection control" to enable the controlling of which wired and wireless clients can connect
to this device. If a client is denied to connect to this device, it means the client can't access to the
Internet either. Choose "allow" or "deny" to allow or deny the clients, whose MAC addresses are not in
the "Control table" (please see below), to connect to this device.
Association control Check "Association control" to enable the
controlling of which wireless client can
associate to the wireless LAN. If a client is
denied to associate to the wireless LAN, it
means the client can't send or receive any data
via this device. Choose "allow" or "deny" to
allow or deny the clients, whose MAC
addresses are not in the "Control table", to
associate to the wireless LAN.
Control table
"Control table" is the table at the bottom of the "MAC Address Control" page. Each row of this table
indicates the MAC address and the expected IP address mapping of a client. There are four columns
in this table:
MAC Address MAC address indicates a specific client.
IP Address Expected IP address of the corresponding
client. Keep it empty if you don't care its IP
address.
C When "Connection control" is checked, check
"C" will allow the corresponding client to connect
to this device.
A When "Association control" is checked, check
"A" will allow the corresponding client to
associate to the wireless LAN.
In this page, we provide the following Combobox and button to help you to input the MAC address.
You can select a specific client in the “DHCP clients” Combobox, and then click on the “Copy to” button to copy the MAC address of
the client you select to the ID selected in the “ID” Combobox.
Previous page and Next Page To make this setup page simple and clear, we have divided the “Control table” into several
pages. You can use these buttons to navigate to different pages.
Example:
40