Konig Electronic WLAN router 300 Mbps - Manual (Page 42)

3.3.3.5 Miscellaneous Items
Remote Administrator Host/Port
In general, only Intranet user can browse the built-in web pages to perform administration task. This feature
enables you to perform administration task from remote host. If this feature is enabled, only the specified IP
address can perform remote administration. If the specified IP address is 0.0.0.0, any host can connect to
this product to perform administration task. You can use subnet mask bits "/nn" notation to specified a group
of trusted IP addresses. For example, "10.1.2.0/24".
NOTE: When Remote Administration is enabled, the web server port will be shifted to 88. You can change
web server port to other port, too.
Administrator Time-out
The time of no activity to logout automatically. Set it to zero to disable this feature.
Discard PING from WAN side
When this feature is enabled, any host on the WAN cannot ping this product.
SPI Mode
When this feature is enabled, the router will record the packet information pass through the router like IP
address, port address, ACK, SEQ number and so on. And the router will check every incoming packet to
detect if this packet is valid.
DoS Attack Detection
When this feature is enabled, the router will detect and log the DoS attack comes from the Internet. Currently,
the router can detect the following DoS attack: SYN Attack, WinNuke, Port Scan, Ping of Death, Land Attack
etc.
VPN PPTP and IPSec Pass-Through
Virtual Private Networking (VPN) is typically used for work-related networking. For VPN tunnels, the router
supports IPSec Passthrough and PPTP Passthrough.
42