Konig Electronic Distribution board with USB remote control - Manual (Page 6)

6
1. Hold the USB Transmitter close to the Surge Protector.
2. Press and hold the learning button on the Surge Protector for 5 seconds. At this time, the POWER
SAVE ON indicator light will flash.
Note: you can release the button once the indicator light flashes.
3. When the indicator light starts to flash, within 5 seconds, press the button on the USB Transmitter
to pair it with the Surge Protector.
4. If the Surge Protector has successfully learned the code from the USB Transmitter, the POWER
SAVE ON indicator light will go from flashing to solid light, then go off.
5. Repeat steps 2~4 if learning is not successful.
Specifications:
Wireless USB Transmitter
* ON/OFF Button
Press the button to remotely turn the Power Save Outlets on/off.
* Activation Indicator Light
The red light illuminates to indicate that the USB Transmitter is being activated.
* Wall Mount Stand for USB Transmitter
The stand can be used as a wall mount or docking stand.
Battery Type:
Use ONLY A23 12 V Alkaline
Battery Life: Approx. 3-6 months
Activation indicator: Red LED
Wireless Range: Up to 25 ft (Open Space)
Technical product information:
CMP-POWG20
* 1 “Always-On” Outlet
Provides continuous power for connected devices.
* 5 “Controlled” Outlets
Controlled on/off by USB Transmitter.
* Surge Protection LED
The red indicator light shows that the surge protector is working.
* Power OK LED
The green indicator light shows that the utility power is powering the outlets.
* Blue Light Save ON Indicator
Indicates that the save socket outlets are fed with power.
* Power Save Outlets with LED
Turns ON/OFF automatically depending on whether the USB Transmitter is connected to a PC or Laptop.