Konig Electronic Blood pressure monitor - Manual (Page 4)

4
4. BODY POSTURE DURING MEASUREMENT
Sitting Measurement
a. Sit
upright
b. Place the arm with the cuff in front of you with your elbow
resting on a desk or table with the palm up.
c. The cuff should be at the same level as your heart.
d. Placing your arm on the monitor‘s plastic case as shown
in the picture aids in maintaining a correct and still arm
position.
5. TAKING A MEASUREMENT
a. With the cuff wrapped around your arm and your body
in a comfortable position, press and hold the button
“START” until the LCD display is activated. The display
will fi rst verify then it will set to read all zeros.
b. Once the LCD display reads all zeros, the monitor will
then pump up the cuff, then release the air pressure
from the cuff and then display the blood pressure and
pulse rate measurements ont he LCD display.
c. Re-measuring
If you want to measure again, just press the “START”
button.
6. READING MEASUREMENT RESULTS
The LCD display will automatically show the systolic and diastolic blood
pressure reading in mmHg units after each measurement. The heart rate is
also displayed in pulse per minute next to the “♥” symbol.
7. TURNING THE MONITOR POWER OFF
The monitor power will turn-off automatically after 3 minutes of non-use after measurement
displaying. Alternatively, you can press and release the button “START” to manually turn off
the monitor.