Konig Electronic Gas detector - Manual (Page 2)

ENGLISH
2
Introduction
Guarantee your own safety in the house with this useful free standing
flammable gas alarm, household type made for indoor use only. When the gas
concentration reaches a certain level the detector provides a visual and audible
signal.
Warning
The service life of the gas detector is for 3 years guaranteed. For optimal
protection we recommend replacing the gas detector every 3 years.
Specifications
• Detectable gases: Natural gas: methane, ethane, propane, and butane.
Liquefied petroleum gas (LPG): propane, butane, propylene and butylene
• Power: 100-240 V AC~ 50/60 Hz
• Rated load: < 2 W
• Alarm level: 3% LEL~20% LEL
• Alarm volume: > 85 dB
• Temperature range: -10°C ~ 50°C
• Relative humidity: < 97% RH
• Storage temperature: -10°C~+40°C
• Dimensions: 67 x 67 x 112 mm
• Weight: 122 g
Where to install the gas detector
Before installing the gas detector we recommend checking, which type of gas
is relevant for the room(s) you are placing a gas detector in.
Natural gas and town gas
It should be installed in the room(s) where a gas leak is most likely to occur;
installed above the level of a possible gas leak and near the ceiling; typically
0.3 m from the ceiling, in a place where air movement is not impeded by
furniture and furnishings.
LPG
It should be installed in the room(s) where the most frequently used appliance
is accommodated and where a leak is most likely to occur. Install as low as
possible; typically 0.1 m above the floor and in a place where air movement is
not impeded by furniture.