LA Audio MPX10 - Manual (Page 27)

Page 27
The 75Hz high pass filter is useful for removing subsonics such as wind
and stage noise and will help produce a much tighter bass and vocal
sound.
M A K I N G A C O M P R E S S O R F R E Q U E N C Y C O N S C I O U S
Inserting an equaliser such as the Millenium EQX20 (or even the EQ from
the MPX10) into the side chain of the compressor will make it more
sensitive to certain frequencies. Examples of this technique are De-Essing
and De-Popping.
S P E C I A L E F F E C T S
A passable telephone voice can be created by cutting frequencies below
300Hz and above 3kHz. Use the LMF and HMF sections, lowest Q (CW)
setting and adjust their respective FREQUENCY controls accordingly.
E N H A N C I N G T H E F A C I L I T I E S O N Y O U R M I X I N G
C O N S O L E
Patch any or all of the sections of the MPX10 into a channel or Group insert
on your console to add Expander, Compressor and EQ processing to your
signal path.
5 . 5 O U T P U T
The Output section of the MPX10 provides output level adjust and signal
level metering. In general the OUTPUT control will be kept at '0' (12
o'clock) whilst setting-up and then only adjusted if the following equipment
is being under or over driven.
Remember when using OUTPUT to reduce signal levels there is a danger
of the MPX10 clipping internally.
The '0' led on the OUTPUT LEVEL meter lights when +4dBu (at the XLR)
or -10dBV (at the TRS jack) is present at the output connectors.