Lab.gruppen C Series 5:4X - Manual (Page 37)

C Series C 20:8X, C 10:8X, C 10:4X and C 5:4X Operation Manual rev. 1.1.4
Appendix
30
The current versions of DeviceControl software and
the DeviceControl Operation Manual are available for
download on our web site: www.labgruppen.com
5.7.6 Third Party Control and Monitoring Capabilities
The NLB 60E NomadLink Bridge & Network Controller can be integrated with third party control systems via
its Ethernet connection. All amplifier control functions, fault and warning notifications that would otherwise be
displayed via the DeviceControl software can be replicated in a third party control GUI.
Please note that NLB 60E Firmware Ver 2.1.0 (or later) must be used in order to utilize the third party control
and monitoring capabilities of the NomadLink network. Both the firmware package and the control protocol
documentation, which describes the functionality and programming requirements for third party integration,
can be found under the Software & Firmware section of our website at:
http://labgruppen.com/index.php/support/software_firmware/
6. Appendix
6.1 Maintenance
During normal operation your C Series amplifier will provide trouble-free service. The only user maintenance
required is to periodically vacuum clean the foam dust filters behind the front grille.
In some extreme cases it may be necessary for authorized service personnel to clean the inside of the amplifier
in order to safely remove dust or other build-ups which may occur during prolonged normal usage. If you are
using your amplifier in a heavy-duty application, it is recommended to have your amplifier serviced every three
years purely as a preventative action.
6.2 FAQ
Following are common questions asked about Lab.gruppen C Series power amplifiers together with helpful
answers.
Q: What is the input sensitivity of the amplifiers?
A: Input sensitivity is calculated from the amplifier gain, maximum output voltage and load. As gain and output
voltage are adjustable in C Series amplifiers, you need to look this information up in a table found in the Ap-
pendix section of this manual. Input sensitivity also is automatically calculated in the DeviceControl software
application.