Lab.gruppen NLB 60E NomadLink - Manual (Page 5)

NLB 60E Operation Manual 5
See table below: •
Voltage Line plug according to standard
110-125 V UL817 and CSA C22.2 no 42.
220-230 V
CEE 7 page VII, SR section
107-2-D1/IEC 83 page C4.
240 V
BS 1363 of 1984.
Specification for 13A fused plugs and switched and
unswitched socket outlets
This equipment should be installed near the socket outlet and disconnection of the device should be easily accessible. •
To completely disconnect from AC mains, disconnect the power supply cord from the AC receptacle. •
The mains plug is used as the disconnect device and shall remain readily accessible. If mounted in a 19” rack causing the mains •
plug not to be easily accessible, then the mains plug for the entire rack must be readily accessible.
Do not install in a confined space. •
Do not open the unit - risk of electric shock inside. •
Caution:
You are cautioned that any change or modifications not expressly approved in this manual could void your authority to operate this •
equipment.
Service:
There are no user-serviceable parts inside. •
All service must be performed by qualified personnel. •
2.4 EMC / EMI
This equipment has been tested and found to comply with the limits for a Class B Digital device, pursuant to part 15 of the FCC rules.
These limits are designed to provide reasonable protection against harmful interference in residential installations. This equipment
generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna. •
Increase the separation between the equipment and receiver. •
Connect the equipment to an outlet on a circuit different from that on which the receiver is connected. •
Consult the dealer or an experienced radio/TV technician for help. •
For Users in Canada:
This Class B digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.
IMPoRtAnt sAFetY AnD oPeRAtIon InstRUctIons 2